Analytical Technology A15 Especificaciones descargar pdf (Pagina 18)

ATI A15/66 Residual Sulfite Monitor

O&M Manual

Rev-W (8/10)

ACID PICKUP TUBING CONNECTION

A special rubber stopper with a ceramic support tube is supplied for the acid bottle. After the acid

bottle has been filled, insert the stopper into the bottle and press in securely. A length of pickup tubing is

also supplied for the stopper assembly. One end of this tubing should extend to the bottom of the acid

bottle inside the ceramic tube.

After the acid bottle has been placed into the bracket or on the mounting panel shelf, attach the

other end of the pickup tubing to the connector on the reagent pump. The reagent pump has a small barb

connector on the right side. Press the pickup tube carefully onto each of this barb, being careful not to

pull on the pump tubing. The tubing from the acid bottle can be shortened if there is an excess once

mounting is complete. Once all connections are made, be sure that the pickup tube extends to the bottom

of the bottle inside the ceramic guide.

Figure 9 - Solution Feed Assembly

CAUTION: Use extreme care in handling of the acid used with this analyzer.

Always wear eye protection and acid resistant gloves when working

with this acid. Sulfuric acid can cause eye damage and/or severe

burning of exposed skin.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 40 41

Sin comentarios

Analytical Technology A15 Especificaciones Pagina 18